The Japanese maple that Walter Pall uses to illustrate his 'hedge-cutting method.' This photo was taken four years after Walter started working with this tree. The before photo is below
Continuing with Walter Pall… we originally ran this post on Walter’s hedge-cutting method in 2013, but it’s so good that it’s worth another look
I first learned about hedge shearing bonsai from Jim Smith (sadly now deceased), a highly respected American Bonsai Artist and grower who worked primarily with tropical and sub-tropical bonsai. Because Jim lived in Florida, I figured that hedge shearing was only used in the tropics or sub-tropics, due to rapid rates of growth and recovery
That was until I began field growing larches here in Vermont and decided that the only way to keep up is to use my sword shears (large one-handed shears with long blades that I originally learned about from Jim) and simply keep cutting back to the desired silhouettes (while letting some lower branches grow unrestrained for a while, in order to create taper). At least while they’re in the ground. However, until we originally posted this (2013), I didn’t know about Walter Pall’s hedge-cutting method, which as it turns out is considerably more detailed and sophisticated than mine
FALL POTTING SEASON SPECIAL
25% OFF LIST PRICES
ON ALL HIGH IMPACT PLASTIC BONSAI POTS
25% OFF LIST PRICES
ON ALL BONSAI SOIL & SOIL INGREDIENTS
–
–
BeforeQuoting directly from Walter… “2008-05: The tree arrived in my garden in this state. The previous owner had kept it in Akadama mush and thought that he would automatically improve the tree by pinching. The crown is much too wide and flat and the leaves hide poorly structured branches. Many branches are dead. The Nebari could be much better and the maple is planted too high in its pot.”
“Well, a few decades ago when the first bonsai trees were brought to the West, the purchasers asked how they should care for these trees. The answer was given so that no mistakes could be made. It was assumed that the owners wanted to keep the trees in the state in which they purchased them. The pinching was recommended because it is useful for trees that are ‘finished’ and ready for exhibition or sale. Nobody thought at that time that the Westerners would ever be able to develop bonsai themselves.
“In the developmental phase, the goal is clearly to improve the tree. The trunk and the branches must be thickened, pruning wounds must close and the tree is to develop so many new shoots that one has a choice of useful branches. The nebari should also improve significantly. At this stage, the immediate image is secondary to the future beauty. That is why leaves can be large and the tree can look ugly for the longest time. To achieve these goals, the tree needs as much excess energy as possible which it can only obtain through the photosynthetic activity of as many leaves as possible. If exactly those sources of energy are removed too early, then the tree can’t develop. In the worst case, it dies a slow death.”
As you can tell from the sacrifice branches, Walter's methods involve more than just hedge shearingWalter continued from above…”2009-01: A deciduous tree can be much better evaluated without its leaves. It is now apparent that the center tree ought to be much thicker and somewhat higher. The previous owner didn’t achieve much by many years of pinching. It looks rather poorly developed. The pot by Bryan Albright seems over powering.”
“The numerous leaves produce lots of energy in the form of carbohydrates that moves downwards through the branches and is deposited in the branches, the trunk, and finally the roots. The result is that branches and trunk thicken, that the surface roots – the nebari – also thicken, and that the roots grow strongly. At the same time, many new visible and dormant buds develop. The entire system “tree” is strengthened and it has good reserves for any setbacks. A radical cutback is such a setback.
In Central European climate about six to eight weeks after the first flush, in our area from the middle of May to the beginning of June, the tree is then cut back with big sheers to its previous silhouette. It is irrelevant where exactly it is being cut, or if any leaves are cut. This actually ought to occur as a partial leave pruning will allow light and air into the crown of the tree. All other growth inside the silhouette is not touched but strengthened with this method. And the tree is strongly encouraged to bud out again.”
The final photo in Walter's article
Walter continued from above… “2013-02: The tree was repotted into a very suitable pot by Walter Venne from Germany. The results of the development thus far are quite presentable. But is is by far not the end of the development. Much has changed in five growth periods, yet the work continues as before. In another five years the tree will be better again. The drawback, however, will be that he tree is not really presentable during much of that time.”
The above comments and photos are just a sampling from Walter Pall’s ground-breaking article on his hedge-cutting method.
The following photos are not by Walter
Our Sword shears work quite well for the hedge cutting method
Podocarpus macrophylla by Jim Smith. My best guess is that Jim used his own hedge shearing method to develop this tree. Photo is from The Art of Bonsai Project.
NEW SPECIAL
ALL BONSAI TOOLS & GARDEN TOOLS
25% OFF LIST PRICES
INCLUDES TOOL ROLLS, KITS & SETS
INCLUDES NON-HYDRAULIC TURNTABLES
ALSO SIEVES & WATERING TOOLS
ALL OTHER BONSAI TOOLS & GARDEN TOOLS
FREE Shipping* on most Continental U.S. orders 75.00 or more
but only if you choose free shipping when you check out
*Beginning Soon FREE Shipping
will no longer apply to Wire, Soil & Non Hydraulic Turntables
FREE Shipping will continue to apply to Green T Turntables
*In order to keep our prices down, soon we will no longer ofter free shipping on wire. This is primarily due to increase costs, especially new import duties combined with the weight of wire and a small handful of other heavy products
–